Build A Ramp For Your Shed

This will save you a little time and excavation effort.

Build a ramp for your shed.

Pressure treated lumber rated for ground contact should be used to build a shed ramp. How to build a shed ramp put it together cut your frame with the right angles from the slope calculations above. Attach a support plank to the exterior of the shed between the bottom of the door and the ground. Make sure to consider these when building a garden shed ramp.

One alternative is to skip the ledger and end board and attach the ramp joists directly to the floor joist with metal hangers. We used a 2 x 4 to estimate a comfortable slope for our ramp and we staked out an area just big enough to fit the concrete blocks. The length of the ramp will be governed by the height from the external ground level to the shed floor and the slope that you choose. Dig a small trench the full width of the lip of the shed where the 4x4s will touch the ground.

Front of the shed for the access ramp. After that we dug a shallow 4 hole for the concrete blocks. Along with slope and size there are a few other factors needed when learning how to build a shed ramp. The larger you make the gap the larger the bump at the end of the ramp.

It is essential to pour a concrete slab at the ends of the joists as you need to support them properly. There are many ways to build a shed ramp. The down side is that the top and bottom edge of the sheeting will not be fully supported. If you want a shed ramp that withstands heavy loads you will also need to think about additional concrete reinforcement on the ground.

Make sure the framing is not too far apart or the boards on top may sag over time. Note the rise between the top of the ledger board and the floor. Make sure to leave enough room under the door for clearance. The nominal size of the boards you select depends on the ramp rise.

This will help to anchor the finished ramp in place and keep it from slipping away from the shed when under a heavy load. The recommended distance is between 3 8 and 1 2. The rise for sheds is often only several inches and riding mowers can easily handle a 1 8 slope. There are two main things to consider for your shed ramp plans.

Cut the support beam to the right size ensure that it is horizontal and affix with screws. A shed ramp is very handy for any backyard is you use a cart or want a better access to the construction. Next we measured the diagonal distance to the shed to check that it was square. A little bit of thought needs to go into the slope for two reasons safety and ease of use.

Therefore we recommend you to plan everything and to adjust the width and the slope of the ramp to suit your needs. Therefore 12 16 framing is appropriate for most shed ramps.