Carpeted Van Panels

It was still a bit strange looking because of the plastic gray panels on top but once the cabinets were in it felt like a cozy warm.

Carpeted van panels.

The full back panels. We used the kiravans easyliner 4 way stretch carpet in wheat to get a nice warm but light look to the van. To install the panels we used 20 countersunk machine screws and finishing washers. All vanax lining kits are manufactured in house to order by our time served joiners and carpenters.

It looks a lot cleaner has a nicer finish and also helps to further insulate the van and reduce condensation build up while cooking and sleeping. Remove all the plastic fittings and screws. Protecting the inside of your van with a plywood lining protects the outside panels from dings and dents caused by loose loads which will inevitably lead to rust marks. We used the kiravans easyliner 4 way stretch.

If you don t want to do this on your own contact us and we can cut the wall panels for your van. Van conversion walls job well done. Measure and cut the liner leave 2 inches of excess liner around the edges. We find that it helps to use cardboard or paper to make templates of your van wall panel areas and trim accordingly.

All our floor panels and interior liners come cut to size and predrilled ready for installation it only takes a few self tapping screws and rivets and a couple of hours and the job is done. The addition of wall panels have started to tie the van conversion together there are still a lot of trim panels that will need to be built and installed to give it that clean finished look. Your van will be fully lined in one or two hours at the most. It looks a lot cleaner has a nicer finish and also helps to further insulate the van and reduce condensation build up while cooking and sleeping.

Here s what our panels looked like as we began to attach them. Use heavy duty trim or automotive headliner adhesive for your vans wall panels. This week i take on the challenges of tracing out the panels for my walls. Jul 22 2018 we decided that rather than paneling the van walls with wood we would carpet it to get a better finish and make it seem warmer.

The back door panel. Hopefully this helps anyone trying to build out their van or any vehicle. Remove all the hard board panels from the interior of the van. Spray the surface of the panel with a generous covering of glue.

We decided that rather than paneling the van walls with wood we would carpet it to get a better finish and make it seem warmer. With all our panels on the van looked amazing.